York County, Maine
Well Pressure Tanks in Arundel, ME
Call (800) 696-9355 or request a visit. Monday to Friday, 8:00 AM to 5:00 PM.
Pressure tank service in Arundel is usually quick, but the diagnosis matters. A low precharge is a five-minute fix; a ruptured bladder or a corroded shell means replacement, and we can tell the difference on the first visit.
Well Pressure Tanks for Arundel homes
Bedrock under much of the town means newer wells are drilled into rock, with flow coming from cracks that vary from lot to lot. Iron and manganese staining, hard water and sulfur smell are the usual complaints, with radon and arsenic as the health questions.
Inland ground is less affected by salt than the coast, though wells near tidal creeks may still deserve a sodium and chloride check. A buyer should ask for the well depth, the pump age and the last bacteria, arsenic and radon results before closing.
What we see in York County wells
Inland homes in York County often have tanks that were installed with the original pump and never checked since. In Arundel, a tank that has done twenty years of service has often lost its charge or its bladder, and replacement is straightforward.
What we check first in Arundel
- Pressure at cut-in and cut-out, against the switch settings
- Air valve, for leaking air or water
- The pump's amperage, in case short cycling has stressed it
How it works
How we handle well pressure tanks, step by step
- 1
Check the precharge
We shut off the pump, drain the tank and measure the air pressure with a gauge. A reading well below the pump's cut-in setting is a common and fixable problem.
- 2
Diagnose the system
Corrosion on the shell, leaks at the base or a hissing air valve each tell us something specific about the tank in your Arundel house.
- 3
Replace or adjust
Where a recharge is enough, we do it and set the pressure correctly. Where the tank has failed, we replace it with a properly sized unit and new fittings.
- 4
Set the pressure
After the work, pressure is checked at the tap, the pump is watched through a cycle and the settings are written down. You will know what normal looks like.
What shapes the job in Arundel
Tanks come in bladder, diaphragm and older air-over-water styles. Modern tanks hold the air in a separate chamber, so the charge does not get absorbed by the water. We explain the difference and what suits the plumbing near Arundel's rural roads between the Kennebunk and Saco areas.
Signs of a failing pressure tank
- A pump that turns on and off every few seconds
- A tank that feels heavy and sounds full all the way up
- An electric bill that has crept up with no change in use
- A house that has grown but kept the original tank
Pressure acting up in Arundel? Call or send a request. We will check the tank and tell you what it needs, and we also work in Saco and Kennebunk.
Well Pressure Tanks in Arundel?
Start with a test. We will explain the results in plain language and only recommend what the numbers support.