York County, Maine
Well Pump Replacement in Wells, ME
Call (800) 696-9355 or request a visit. Monday to Friday, 8:00 AM to 5:00 PM.
Replacement is a chance to ask why the last pump failed. In York County, we look at depth, water chemistry, power quality and pressure tank behavior, since fixing the cause is how the new pump lasts.
Well Pump Replacement for Wells homes
Many homes beyond the main corridor are on private wells, and some neighborhoods have no public water at all. Sandy coastal soils and shallow groundwater make some wells sensitive to rainfall, drought and nearby septic systems.
Wells near the marsh or shore can show changes in sodium and chloride, and iron is a common companion in this kind of ground. Drilled bedrock wells inland can carry arsenic, uranium and radon, so testing matters more than guessing.
What we see in York County wells
Coastal air and water are hard on metal parts. When we replace a pump in Wells, we look for corrosion on fittings, the well cap and wiring, and we replace anything compromised, since salt near Wells beaches, marsh and inland roads accelerates wear.
What we check first in Wells
- Amperage and voltage on the old pump, to understand the failure
- Static water level and well depth, to set the new pump correctly
- A bacteria test after the wellhead was opened
How it works
How we handle well pump replacement, step by step
- 1
Pull and inspect
What comes out of the well tells us a lot. We look at scale, corrosion, cracked pipe and failed splices, and we photograph anything that affects the recommendation.
- 2
Choose the replacement
We also consider the rest of the system: pipe, wire, switch, check valve and tank. A pump is only as dependable as the parts attached to it.
- 3
Reinstall carefully
We set the pump at the correct depth, reconnect power and plumbing and bring the system up slowly. Air is bled from the lines before full pressure is applied.
- 4
Test and document
After startup we confirm pressure, amperage and cycle times. If something is off, we adjust before leaving.
What shapes the job in Wells
A new pump is often matched with a fresh pressure switch, a check valve and, where it makes sense, a new pressure tank. These are inexpensive compared to a pump and prevent many early failures.
Signs a pump is due for replacement
- A pump more than about fifteen years old
- Air or sediment appearing in the water
- A power bill that has crept upward
- A pump that has been replaced before without addressing the cause
Atlantic Water Solutions replaces well pumps across York County, including Wells and Berwick. Ask for a visit and we will start with what the old pump tells us.
Well Pump Replacement in Wells?
Start with a test. We will explain the results in plain language and only recommend what the numbers support.